Symphony Clear Interior Finish

Symphony Clear Interior Finish Application Guidelines
1. Proper substrate preparation and application are imperative for product longevity. Read this entire Info Sheet before applying any product.
2. You should always test any coatings on your specific logs before applying to an entire wall.
3. Apply only to interior walls where the roof is in place, the product is at room temperature, there are no cold drafts and the wood surfaces are between 50 ̊F (10 ̊C) and 90 ̊F (32 ̊C).
4. Tannin staining should be dealt with before applying any interior clear coatings to bare logs. Refer to the section titled “Tannin Staining” for further information on this important topic. If you’ve applied a pigmented coat of stain, tannin staining is usually not an issue.
5. The moisture content of interior wood should be low enough to resist microbial growth before applying any coatings, at least 19% or less. Use a moisture meter to make sure this is a fact. If the wood’s moisture content is higher, wait until it lowers to 15% or less, or add a biocide (such as Stay Clean I/E) to your coating before application.

Symphony Interior Finish Application Information
• New Wood: If you’ve decided to keep your logs natural looking and only want to apply Symphony to bare wood, best results are obtained if you sand the wood to a smooth finish with fine sandpaper. Be certain to remove all dust before finishing. Do not use steel wool; it may cause rust stains. For a smoother finish, sand between coats.
• Finished Wood: Compatibility is a huge issue, so logs that already have some type of stain or sealer on them will need to be tested for compatibility. For best adhesion to non-Sashco coatings, it is usually best to lightly sand
the surface before applying Symphony. For best adhesion to non-Sashco coatings, it is best to lightly sand the surface before applying Symphony. Old finishes may need to be mechanically removed if a lighter appearance is desired.
• Do not dilute. Stir thoroughly before using. Do not shake as this will cause foaming.
• Apply when 50 ̊-90 ̊F. Best results are obtained at 60 ̊-90 ̊F. Avoid applying in cold drafts or areas with no overhead roofs.

Symphony Application Methods
• Brush or spray on two or more coats. More coats will impart a higher sheen.
• If brushing, use a high-quality synthetic bristle brush.
• Back brushing after spraying will enhance penetration into the wood surface. Brush material in the direction of the grain. Do not over-brush (bubbles can form).
• Sand between coats for a smoother finish.

Symphony Dry Time
• Symphony will dry to touch in one hour and can be sanded after two hours (when the air is warm & dry).
• Recoating can be done after 1-2 hours.
• Allow wood that will be handled to dry overnight.
• Actual dry time depends on thickness of coats, temperature and humidity.

Symphony Clean Up and Storage
• Clean fresh material on equipment and hands with soap and water.
• Spray equipment should be cleaned with water followed by cleaning with paint thinner. Use paint thinner to clean dried material.
• While freeze-thaw stable, it is best to store Symphony at moderate temperatures, between 60 ̊F and 80 ̊F. Store in tightly sealed containers.
• Cover the pails when not in use.