Woodguard SWO - Swedish Wood Oil

Preparation Instructions
• Surfaces should be cleaned and free of all loose debris.
• Use only as much as can be readily absorbed by the wood.
• Test before using.
• Do not use on painted surfaces.
• When using wood that has not been kiln dried, wait six months after construction before treating for maximum penetration.
• Moisture content of wood should be less than 18%.

New Decks and Docks
• Allow the deck or dock to dry for two to three months.
• Sweep to remove dirt and debris before application.

Weathered, Untreated Decks and Docks
• Make sure surface is free of all dirt and debris.
• If a new appearance is desired, clean with a pressure washer to remove the gray surface of wood.
• After washing, let the wood surface dry for three days before applying WOODguard SWO.

When Pressure Washing
• To avoid wood damage, and achieve maximum effectiveness, make sure the pressure is set below 500 psi, and keep the nozzle of the power washer approximately one foot from the surface.
• Apply to dry wood for maximum penetration and fastest drying. Do not over apply.

Application Instructions
1. WOODguard SWO penetrates into the wood with only a small portion evaporating. Do not apply to painted or otherwise sealed or highly dense surfaces. If in doubt, apply to a small test area. If the wood absorbs the treatment readily, it is suitable for use.
2. WOODguard SWO does not "DRY" in the conventional sense. It cures into the wood. Blot up any excess SWO left unabsorbed on the surface.
3. Apply above 50 degrees F for fastest cure time. Hot weather promotes a faster cure time. Below 65 degrees F, SWO may become too viscous to spray.
4. WOODguard SWO softens asphalt (including asphalt shingles) - avoid contact.
5. Do not apply if rain is expected within 36 hours.
6. Avoid open flame during application and until the oil has thoroughly penetrated the treated surface.
7. Any subsequent coating applied over SWO must be tested on a remote area to verify compatiblity before application. SWO's highly water repellant system will repel latex coatings and may not be compatible with some oil or alkyd coatings.
8. Until SWO has thoroughly cured, treated area my be slippery.
9. WOODguard SWO may be applied to newly-constructed, pressure-treated decks that are thoroughly dry. Use only enough SWO to be readily absorbed.

Clean Up and Storage
• Use detergent and water on fresh SWO coated brushes and tools.
• If it has had time to cure, mineral spirits or paint thinner may be used for clean up.
• Store in a secure, dry, well-ventilated area protected from extreme temperatures.
• Do not transfer to unmarked containers.
• Keep container tightly closed when not in use.
• Do not store with strong oxidizing agents such as peroxide.

Woodguard Swedish Wood Oil Application & Technical Resources:
• Woodguard SWO Brochure
• Product Guide
• Product Label
• Safety Data Sheet (SDS)